Stock derby

Mon, 19 Jul 2010 04:19:30 +0100

1.Cars 80 newer only,
2.Welding there will no welding on frame seams an no frame plating at all ...only drives door,an bumpers,4 point haylow cage only ..you can run any auto bumper,
3.if car is used you my bend down but NO plating to fix..
4.no gastank protector,call for details on mountin gas tank,,
5.you run any rearend 5 lug,if you run a 98 newer, only can replace rear control arm brackets not hole rearend cradle,,call for more info because dont want any rewelding on frame,you can buy these brackets or make them,
6.you may run any driveshaft
7. Stock trailing arms only
8.stock A-arms
9.no changin front springs
10.you may run any tire
11.no welding trunk or hood or pass doors,chain or wire in 6 spots,you chain or wire to bumper with them 6 spots only
12.stock body mounts only no changing if rusty get cleaner car,,
13. you may add 1 body bolt to each side!so only 2 body bolts can be added
14. you may run engine cradle for motor protection only,,BUT YOU HAVE TO RUN STOCK FRAME MOUNTS FORD OR CHEVY OR MOPAR... no chaining cradle to frame,just wire motor in two spots call for more info if dont under stand,,
15. NO HAMMERIN FRAME OR BODY!
16.YOU MAY RUN DIST, BRACE NOT ATTACHED TO FRAME OR BODY
17.Must have chain wire or 1 bar in middle or winsheild..
18.no tippin front ends at all,,
19. you may move trans crossmember for trans that are larger,3in angle on each side only, cal if dont under stand
20.No radiator protector,
21,Sway arm bar must stay stock or remove
22.REMEMBER THESE ARE THE RULES ,,PLEASE CALL IF YOU NEED ANY HELP UNDERSTANDING
THERE WILL BE A CHEATERS HEAT IF YOU DONT WANT RUN A STOCK CAR!MIX IRON WELCOME IN CHEATER HEAT ONLY NO OUTLAW CARS!500.00 TO WIN
23.These rule are for AUG 8TH700.00 to win,AN SEPT 5TH CHAMPIONSHIP FOR 2000.00 GUARANTEE FOR 1ST PLACE if we have over 40 big derby cars for this stock class we will pay 3000.00 to win ..Only on Sept 5th 75.00 pre entry, or 100.00 day of show comes with 1free pit pass
CALL TODD SORENSENPROMOTIONS FOR MORE INFO 12314256990
.trunks an hood will not be chained or wired till after insection

Mix iron rules

Mon, 19 Jul 2010 04:19:56 +0100

DEMO DERBY RULES... mix iron 4x6 hump plates/ 78newer 22in hump plates show.
All driver must have state I.D. an must 18 years old or parents sig...
Entry fee 50.00 is for car an driver an 1 pit pass
Drivers is responsible any pit members actions!!
Afull face helmetwith chinstrap is required..
NO HOT-RODDING in pit area...
NO leaf wagons or 60s chry imp,limos,4x4..
A DRIVERS MEETING WILL 30 MINUTES BEFORE DERBY STARTS..
Track owner an promotor are not responsible for any thing let at the track or fair grounds..like parts or tool!
All injuries must be reported to officiating crew before you leave the event!
GENERAL PREPARATION
1.All chrome molding ,trim,plastic,fiberglass,an taillight, must be moved..
2.Wiper arms an assemblies,door handles,an antennas must be romoved,
3.Sedan rear seats an station wagon rear seats decking must be removed.
4.Driver seat may replaced and an secured to floor pan.
Rolling down windows is not permitted..car ust be clean off all glass.
FUEL SYSTEM
1.Stock fuel tanks must be removed.
2.A steel fuel cell or boat tank must be used.no plastic tanks..Tanks must be 8 gallons maximum.
3.Tanks must be securely mounted to floor or roll cage or floor..
4.fuel lines must be in side of vehicle..no lines underneath.
5.Fuel injected cars must use high pressure fuel line..Double clamps on rubber lines recommended.
6.Auxiliary fuel pumps are allowed but must be securely mounted in cars.
7.FUEL LEAKAGE OF ANY KIND WILL RESULT IN DISQUALIFICATION

BATTERIES AND WIRING
1.Only one type auto battery allowed.
2.Must be securely fastened to passenger floor.
3.Wiring to motor from inside of car may be ran through the firewall.
FRAME & BUMPERS
1.No skidplates attached to frame or cross member..
2.Only top frame seams from A-arm forward may be welded.
3.NO REWELDIN OF ANY OTHERFRAMES SEAM..
4.PATCHIN RUST HOLES IN FRAME IS OK.PATCHES NO THICKER THEN FRAME.
5.Bodys may be bolted down to frame.5/8"bolt size maximum and may go inside of car.
6.Front frame may be angled/tilted at crushboxes .absolutely no added steel.1/2 welds maximum.
7.One body bolt may be added to each frame rail.If car has stock body bolts you may add 2 body bolts to each side.
8.Any stock auto bumper.
9.BUMPERS MAY BE WELDED SOLID .Brackets may be welded to frame.
10.Bumpers may be welded directly to frame.
11.Bumpers height from ground to bottom of bumper, no lower then 14", no higher then 22"
12.ABSOLUTELY NO OTHER WELDING TO,PINNING, OR ADDED STEEL IN OR ONTO FRAME.
13. NO CONCRETE ...
14.6" TALL MAXIMUM LENGTH CORE SUPPORT SPACER ALLOWED..
15.Humps may be reinforced with a contoured piece of 1/4"x22" maximum length plate.Plates must fit original arch or the frame,and must be placed on the outside only ,1 per plate per side..only on 78newer cars...
16. IF YA HAVE QUESTIONS ON COVERSIONS OR REPAIRS, CALL FOR INFO!
RADIATORS AN COOLERS
1. Radiators must remain in factory position !!!!!
2.Radiators must be held in with wire,ratchet straps,seat beat or banding wire.
3.Angle iron or plate may used on top of core support..This may be welded in place and cannot be wider then 32"Not to exceed 3"wide and 3/8"thick..
4.Coolers must be fasten to car floor board or dash bar.
5.Recommended that coolers be placed in a covered steel box. no plastic containers..All coolers lines must be of steel or high pressure hydraulic..NO RUBBER LINES OR HOSE CLAMPS.
CAGES
1.A single 5" maximum diameter bar may be install up and over roof of car.Bars may not be angled..
2.Over the roof bar may attach to bar behind seat an legs may go straight down to floor only.NO ATTACHING DOWN TO FRAME OR BODY MOUNT LOCATION.
3. NO KICKERS
4.Fuel tank protectors are allowed.
5.Fuel tank protectors may be weld to fire wall only! no boltin to wall or frame...
6.No attachin cage to dist protector in any way!

DRIVETRAIN
1.Engine an transmission mounts be secured with chain ,wire or weld.
2.Altering mounts is allowed. but must not strengthen an part of the body or frame
3.Engine/trans changes are okay.
4.Any auto type rear ends may be used.5 lug max..
5.no floater or 8 lug.Any driveshaft
6.Aircleaners must be left over carburetor.\
7.Exhaust must exit straight up othrough hood or under car.
8.All mufflers an catalytic convertors must be removed
9.any fan .must be covered by hood.
10.Distributor protectors are okay.it must not be or strengthen any other part of the car..
11. Engine Cradles are allowed but cant be attach to distriibutor protector or body or frame to strengthen car!

DOORS
1.ALL doors may be secured shut using weld, wire or chain..
2. Doors may be welded solid but not inside doors just outers.
3.drivers door is recommended you can have drivers door protection..
4.Mud screens are allowed in windsheild area..
5.Drivers doors may be reinforced on the outside ,1/2"thick,12"tallmaximum.
6.NO I-BEAM,CHANNEL IRON,..NO SHARP EDGES..
HOOD AN TRUNK
1.You can wire, weld,chain trunk..
2. trunk can be welded solid
3.if weldin trunk lid to bumper ,16"long, 4" wide,1/4" thick stell strap,chain or wire.
4.you may wire ,chain, or seat belt hood down..6 spots..
5.Trunk lid may be beat down quater may be beat in, no reweldin new seams..speaker deck may beat down..
6.NO WEDGES AT ALL !
7.NO SEDAGONS!
8.Pinching body panels is allowed..
9. rear 1/4 panels must be up.
10. if any questios on USED CARS please call..
TIRE RULES THERE IS NON!

SUSPENSION & STEERING
1.No stuffed, blocked or clamped shocks,Suspension must bounce.
2.All air shocks must be cut!
3. Coil spring may be replaced for height.
4.no truck or industrail leafs or coils springs allowed. must bounce..
5.Tie-rods and upper rearend control arms may be altered
6.Value stem protectors are OK.
7.All wheel weights must be removed.

0THER
1. CARS MUST BE DECORATED IN GOOD TASTE.
2.RECOMMENDED THAT DRIVERS DOOR IS PAINTED WHITE..
3.DRIVER AN PIT CREW MUST SIGN WAIVER/RELEASE OF LIABLILITY FORM BEFORE ENTERING TRACK..
4,ALL CARS MUST PASS INSPECTION BEFORE COMPETING IN DERBY..
5.These rules are for May29th derby an aug 8th,,,will have rules up for july 3rd an sept 4th up after the first derby....thanks to all for the help!

COMPACT CARS ONLY 4 OR 6 CLY FRONT WHEELDRIVE
1.move battrie to pass floor.
2.HIGHLEY RECOMMEND MOVING THE GAS TANK TO BACK SEAT...
3.Only 1 safety bar in side car..also outside drivers door proctection...can weld drivers door solid..
4.any tire
5.call for more info..